DUPONT FILMTEC SW30HRLE-400 Membrane

The DUPONT FILMTEC SW30HRLE-400 delivers high performance over the operating lifetime without the use of oxidative post-treatments and provides high NaCl and boron rejection to help meet World Health Organization (WHO) and other drinking water standards. DUPONT FILMTEC SW30HRLE-400 comes with the unique iLEC™ Interlocking Endcaps that reduce system operating costs and reduce the risk of o-ring leaks that cause poor water quality.

DUPONT FILMTEC SW30HRLE-400 offers high rejection and low total cost of water for seawater desalination.

Advantages

• High flux reduces energy use or pressure required
• Good rejection results in good quality water
• High boron rejection
• Filmtec performance and quality

Important Information

Proper start-up of reverse osmosis water treatment systems is essential to prepare the membranes for operating service and to prevent membrane damage due to overfeeding or hydraulic shock. Following the proper start-up sequence also helps ensure that system operating parameters conform to design specifications so that system water quality and productivity goals can be achieved.

Before initiating system start-up procedures, membrane pretreatment, loading of the membrane elements, instrument calibration and other system checks should be completed.

Please refer to the application information literature entitled “Start-Up Sequence” (Form No. 609-02077) for more information.

Operation Guidelines

Avoid any abrupt pressure or cross-flow variations on the spiral elements during start-up, shutDUPONTn, cleaning or other sequences to prevent possible membrane damage. During start-up, a gradual change from a standstill to operating state is recommended as follows:

• Feed pressure should be increased gradually over a 30-60 second time frame.
• Cross-flow velocity at set operating point should be achieved gradually over 15-20 seconds.
• Permeate obtained from first hour of operation should be discarded.

General Information

• Keep elements moist at all times after initial wetting.
• If operating limits and guidelines given in this bulletin are not strictly followed, the limited warranty will be null and void. Refer to DUPONT™ FILMTEC™ Reverse Osmosis and Nanofiltration Element Three-Year Prorated Limited Warranty (Form No. 609-35010)
• To prevent biological growth during prolonged system shutDUPONTns, it is recommended that membrane elements be immersed in a preservative solution.
• The customer is fully responsible for the effects of incompatible chemicals and lubricants on elements.
• Maximum pressure drop across an entire pressure vessel (housing) is 50 psi (3.4 bar).
• Avoid static permeate-side backpressure at all times.