DUPONT FILMTEC SW30XHR-440 Membrane

The DUPONT FILMTEC SW30XHR-PRO-440 element is the highest rejection seawater RO element in the DUPONT FILMTEC element portfolio, enabling stringent water quality requirements to be met reliably with single pass seawater systems in most situations. In addition, the combination of high active area and thick feed spacer results in higher productivity and lower cleaning frequency, which enable sustainable lower lifecycle cost.

Advantages

• High flux reduces energy use or pressure required
• Good rejection results in good quality water
• High boron rejection
• Filmtec performance and quality

Important Information

Proper start-up of reverse osmosis water treatment systems is essential to prepare the membranes for operating service and to prevent membrane damage due to overfeeding or hydraulic shock. Following the proper start-up sequence also helps ensure that system operating parameters conform to design specifications so that system water quality and productivity goals can be achieved.

Before initiating system start-up procedures, membrane pretreatment, loading of the membrane elements, instrument calibration and other system checks should be completed.

Please refer to the application information literature entitled “Start-Up Sequence” (Form No. 609-02077) for more information.

Operation Guidelines

Avoid any abrupt pressure or cross-flow variations on the spiral elements during start-up, shutdown, cleaning or other sequences to prevent possible membrane damage. During start-up, a gradual change from a standstill to operating state is recommended as follows:

• Feed pressure should be increased gradually over a 30-60 second time frame.
• Cross-flow velocity at set operating point should be achieved gradually over 15-20 seconds.
• Permeate obtained from first hour of operation should be discarded.
• Please refer to the product technical manual.

General Information

• Keep elements moist at all times after initial wetting.
• If operating limits and guidelines given in this bulletin are not strictly followed, the limited warranty will be null and void. Refer to FILMTEC™ Reverse Osmosis and Nanofiltration Element Three-Year Prorated Limited Warranty (Form No. 609-35010).
• To prevent biological growth during prolonged system shutdowns, it is recommended that membrane elements be immersed in a preservative solution.
• The customer is fully responsible for the effects of incompatible chemicals and lubricants on elements.
• Maximum pressure drop across an entire pressure vessel (housing) is 50 psi (3.4 bar).
• Avoid static permeate-side backpressure at all times.
• Wear protective eye shields, gloves, and sleeves to avoid prolonged contact with eyes, skin, and clothing.